Skip to content

Mounting and Alignment

January 14, 2019

Alignment of linear guides and drive screws is critical linear motion systems. The use of a dial indicator or a laser alignment device is required for this procedure. Without a measuring device, it will be impossible to define exact parallelism and height alignment of the assembly. Improper alignment can cause excessive noise, binding, vibration, rough operation and outright failure after only a few operating cycles. In addition, for screw driven systems, it is extremely important that the ball nut is only loaded axially. There should not be any radial or side-to-side loading. The ball nut is rated for “pure” thrust load. If a dial indicator is not used, it will be difficult to measure any height variances.installation alignment

Lintech provides detailed instructions for the installation of linear motion systems in their Component Service Manual.

No comments yet

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google photo

You are commenting using your Google account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s

%d bloggers like this: